|
Quantity
|
Total
|
||
|
|
|||
ASPAR EMD 200-18.0 INOX is the stainless-steel execution of the base EMD 200-18.0 model for a straight stair flight up to 18 m. It is a separate material execution, not a different base model; the configuration is checked against the site parameters.
Model specifications
| Parameter | Value |
|---|---|
| Load capacity | up to 200 kg |
| Maximum lifting height | up to 18 m (depends on stair angle) |
| Platform size | from 900 × 1000 mm |
| Mechanism type | manual folding |
| Power supply | 220 V |
| Control voltage | 24 V |
| Material | stainless steel |
| Route length | up to 18 m |
| Execution identity | Base model EMD 200-18.0; INOX = stainless-steel execution |
The values apply to this model or the stated execution. If a parameter depends on the configuration, ASPAR confirms it after reviewing the input data.
When to consider this model
EMD 200-18.0 INOX retains the base identity of EMD 200-18.0 but uses a stainless-steel execution. First, the suitability of the base platform for the straight stair flight is checked, followed by the need for the INOX material execution.
What to send for calculation
- height difference or stair-route parameters
- required platform dimensions and access direction
- a photo, measurements or drawing of the installation area
- indoor or outdoor conditions
- available power supply
What affects the cost
Cost is determined after checking the input data. The calculation depends on the length and geometry of the stair route, landing zones, platform execution, installation conditions and the agreed scope of work. The price depends on the selected configuration, installation conditions and agreed scope of work.
Implementation and support
ASPAR agrees the technical solution and may perform installation and commissioning within a specific order. The division of preparatory and electrical work is defined separately for each site.
ASPAR project experience
See the implemented inclined-platform project — an example of equipment use in this category. Selection of EMD 200-18.0 INOX takes account of the parameters of the specific site.
Documents and conformity
The ASPAR certification and conformity centre provides documents for this equipment category. Conformity of a solution for a specific site is determined with its installation conditions taken into account.
Useful resources
Frequently asked questions
How does EMD 200-18.0 INOX differ from the base EMD 200-18.0?
INOX is the stainless-steel execution of EMD 200-18.0. This is not a basis for merging the two execution pages or carrying over every project parameter without verification.
What information is needed to check the stair route?
A photo, measurements or drawing of the straight flight, the route length and angle, landing zones and available space are required. ASPAR checks applicability after receiving this information.
Next step
Send a photo, measurements or drawing of the stair route. ASPAR will check the geometry and model applicability and prepare a configuration for calculation.
Next action: Request a calculation