A vertical platform integrated into an existing shaft for a developer’s site
In Horishni, ASPAR installed an electromechanical vertical platform lift for persons with disabilities in an existing shaft. The project uses a pass-through stainless-steel platform rated for up to 250 kg, with 2600 mm travel, a 220 V power supply and a 1400×1100 mm usable platform. The photographs document the installation stage before commissioning.
Integrate a lift into an already constructed shaft
The developer’s site required an accessible vertical route with lifting equipment fitted into the available shaft. The configuration had to match the actual shaft geometry and two landing levels.
The pass-through arrangement allows entry at one landing and exit from the opposite side at the other.
An electromechanical pass-through platform in stainless steel
ASPAR manufactured an electromechanical vertical platform for this site. Stainless steel is used for the exposed platform and guard elements, while the structure is adapted to the existing shaft.
The configuration was manufactured to match the existing shaft and the required pass-through route between levels.
The equipment is installed, but the site has not yet been commissioned
At the time of photography, the platform was installed in the shaft while construction and finishing work remained in progress. The blue protective film is still on the deck, so the images document installation rather than the final appearance of a completed site.
The final appearance will be available after the building work is complete and the protective film has been removed.
Vertical accessibility platforms for new and existing buildings
Each configuration is selected around the travel, shaft dimensions, entry directions, required capacity, finish materials and readiness of the building works.
Need to install a platform lift in an existing shaft?
Send the shaft dimensions, required travel, entry arrangement and photographs of the installation area. ASPAR engineers will prepare a configuration for your site.