|
Quantity
|
Total
|
||
|
|
|||
ASPAR EMT 2000 is a cable-driven vertical lift platform for people with disabilities and other mobility-impaired groups, with a lifting height of up to 2 m and straight-through access. ASPAR determines the final configuration from the installation-site parameters.
When to consider this model
EMT 2000 has a lifting height of up to 2 m and straight-through access. Before selection, the height difference, dimensions of the installation area, approach direction and operating conditions must be checked; category certification does not replace assessment of the entire building.
What to send for calculation
- height difference or stair-route parameters
- required platform dimensions and access direction
- a photo, measurements or drawing of the installation area
- indoor or outdoor conditions
- available power supply
What affects the cost
Cost is determined after the site parameters and equipment scope are clarified. The calculation depends on lifting height, platform dimensions, access direction, installation location and conditions, and the work required.
Implementation and support
ASPAR agrees the technical solution and may perform installation and commissioning within a specific order. The division of preparatory and electrical work is defined separately for each site.
Example of an ASPAR installation
See an example of a cable-driven vertical lift installation for an insurance company in Dnipro. It shows equipment of this type; the configuration for a specific site is selected from its parameters.
Documents and conformity
Information on certification and conformity for this equipment category is available in the ASPAR conformity centre. Requirements for a specific site are considered based on its conditions.
Useful resources
Frequently asked questions
When should a vertical platform be compared with an inclined platform?
When the task permits different travel paths. The solution depends on the height difference, entrance or stair geometry, available space and installation conditions.
Are all EMT 2000 parameters fixed?
No. The key model parameters are listed above. Part of the configuration is selected for the specific site and equipment scope.
Next step
Send the input data and a photo or drawing of the installation area. ASPAR will check model applicability and prepare a configuration for calculation.
Next action: Request a calculation